|
|
|
Pine floorsMost pine flooring is yellow pine. It is found mostly in older construction. In homes built 60 to 100 years ago, it is usually found on the third and second floors over a sub-floor, as well as in attic areas. In homes built 100 to 250 years ago, you are more likely to find square edge pine board flooring. In many cases, there will be no sub-floor. Attic flooring is usually a flat grain, often found in the attic spaces of older homes. Hardwood floorsHardwood floors are very common in today’s market. The most commonly used wood is oak. It is usually identified by its hardness and is normally installed in two types—3/4-inch by 2 1/4-inch T&G boards, or 5/16 by 2-inch, square edge boards that are surface nailed. The material can be easily filled, sanded, stained and finished. Parquet floors are usually high quality floors. Generally, they are 12 x 12 x 1/2 inches thick. They can be square edge or T&G, and most of the time are installed with an adhesive. The most common problem with this flooring is that the adhesive becomes loose. You can usually sense loose flooring when you walk over the loose area. Floors tend to loosen with moisture or conditions with high relative humidity, and in high traffic areas. Pre-finished hardwood flooring (e.g. Bruce) comes in a number of forms:
These floors look great and are durable. They have a “V” joint between the pieces, which makes re-finishing difficult. This joint collects dirt and greases over the years, which makes cleaning and preparing the floor tedious. Stains - Stains are very difficult to remove from any type of wood flooring, whether it is site finished or refinished at the factory. Sanding can remove some of the stains, but deep, oil-penetrating stains are almost impossible to totally remove from the wood. Pet stains (e.g. urine) may sand off if they are minor and superficial, however, if they are serious stains, replacement of the affected areas may be necessary. CarpetCarpet should be checked for proper stretching and securing of the seams, mostly for safety. Loose carpet may pose a tripping hazard. The carpet should be checked for dirt and stains that might not come out, which may require replacement. Carpeting can also affect the air circulation of the HVAC system. If the carpet is extremely thick, and the HVAC system doesn’t have individual returns, it could block the space underneath some of the doors and restrict adequate air circulation to those areas. In such case, the door could be undercut. VinylAsphalt vinyl, vinyl and vinyl-asbestos - All of these tile and sheet
Vinyl-asbestos tile is also dependable and durable. It was the tile of choice for decades until it was discontinued for residential application in 1973. Manufacturers had until 1978 to deplete their stock and cease distribution. The concern is related to the asbestos that is in the tile. Asbestos has been used for almost 100 years as a binder in tiles. The asbestos in tile is not considered a health hazard because it is not friable or airborne. TileCeramic Tile - Ceramic tile can be set in a wet bed system or thin set (mastic). A wet bed system, referred to as “mud” in the trade, is a cement, sand and lime mix similar to the mix used for the ground coat of a three-coat plaster wall. Thin set/mastic is an adhesive that has enough body to help smooth and fill minor imperfections that may exist in the sub flooring, and secure the tiles to the floor or wall. The wet bed system is more desirable and longer lasting, but it is more expensive. New products, such as the mastics and waterproof boards, are making wet bed systems extinct. Loose tile, due to failing and water-damaged substrates, is a major problem. Tap floor tile in suspicious areas and gently tap and press wall tiles to locate loose and possibly damaged areas. Grouting around the tub and shower should be kept up, as failure to do so leads to the deterioration of the tile and allows water to seep into the areas and the substrates below. Grout between the tiles is more stable than grout at dissimilar materials, such as where the tile meets the tub or wall. These areas need a flexible material, such as silicone or similar caulk. Wood floors will generally be more flexible than ceramic tile. Grout with plasticizers should be used over wood floors. This will allow the grout to flex between the tiles instead of causing the tiles to crack. ________________________________________________________________________ |
goods
are dependable, as long as the installation is performed
properly. There is a wide range in quality. Loose tiles are often
a sign
of moisture or workmanship concerns, particularly in the kitchen and
basement areas.